: The unit maintains tight control with a basic error of
Relay contact output of 220V/3A (resistive load) or 1A (inductive load). xmtd-2201 manual
The "P" (Proportional) band may be too narrow. Run the Auto-tuning (At) function to fix this. : The unit maintains tight control with a
relies on or dial switch settings. It’s a "set-and-forget" piece of hardware built for stability. In fact, it's designed to store your upper and lower limits even during a total power failure. relies on or dial switch settings
simultaneously. This allows operators to monitor real-time temperature fluctuations alongside their target temperature without switching between screens. Made-in-China.com 2. Cold End Automatic Compensation
Before you claim your XMTD-2201 is defective, verify: ☑ The sensor type ( SCC ) matches your physical probe (K, J, Pt100). ☑ The wiring matches the terminal diagram (not all clones are the same). ☑ The OP-A is set to 0 for heating. ☑ The T cycle time is appropriate for your output device. ☑ Auto-tune has been run at least once.